Sun Microsystems StorEdge S1 AC100, Installation And Maintenance Manual

Page: 62 / 128

26 StorEdge S1 AC100 and DC100 Installation and Maintenance Manual • March 2002
FIGURE 2-10
Routing the Wires Out of the Bottom Portion of the Strain Relief Housing
3. Insert the tie wrap into the bottom portion of the strain relief housing as shown in
FIGURE 2-11
.
FIGURE 2-11
Securing the Wires to the Strain Relief Housing
4. Loop the tie wrap over the wires and back out of the strain relief housing and
tighten the tie wrap to secure the wires to the strain relief housing.
5. Lower the top portion of the strain relief housing (
FIGURE 2-12
) so that the three
prongs on the top portion insert into the openings in the DC connector, and push
the top and bottom portions of the strain relief housing together until they snap
into place.