22
StorEdge S1 AC100 and DC100 Installation and Maintenance Manual • March 2002
FIGURE 2-4
Power Connector on the DC Power Supply
▼
To Assemble the DC Input Power Cable
1. Turn off power to the DC power source through the circuit breakers.
Caution –
Do not proceed with these instructions until you turn off the power to the
DC power source through the circuit breakers.
2. Get a DC connector from the ship kit.
3. Locate the three wires coming from the DC power source used in the connection
to your unit:
■
-48V
■
GND (Ground)
■
-48V Return
4. Strip 5/16 of an inch (8 mm) of insulation from each of the wires coming from the
DC power source.
Caution –
Do not strip more than 5/16 of an inch (8 mm) from each wire. Doing so
will leave uninsulated wire exposed from the DC connector after the assembly is
complete.
FIGURE 2-5
Stripping the Insulation From the Wire
3
2
-48V
-48V RTN
GND
1
5/16 in. (8 mm)
Summary of Contents for StorEdge S1 AC100
