Sun Microsystems StorEdge S1 AC100, Installation And Maintenance Manual

Page: 41 / 128

Chapter 1 StorEdge S1 AC100 and DC100 Overview 5
Components at the Front of the
Enclosure
The front bezel contains a blank nameplate and five LEDs. You can use the
nameplate to attach an identifying sticker or label to the system. If you want to
remove the nameplate so that you can attach it to another system, see “To Remove
the Nameplate on the Bezel” on page 7.
For information about the front panel LEDs, see “Front Panel LEDs” on page 67.
You can remove the front bezel to access the hard drives and to view the SCSI ID
LEDs. For information about how to remove the bezel, see “Removing the Front
Bezel to Access the Disk Drives” on page 58.
For more information about these LEDs, see “To Check the Binary SCSI ID LED
Display” on page 69. Alternatively, a pull-out card attached to the system
summarises the information they give.
The StorEdge S1 storage enclosure accepts up to three 1-inch high drives. For more
information on the StorEdge S1 disk drives, see “Adding, Removing, and Replacing
Drives” on page 57.
FIGURE 1-2
Front of StorEdge S1 Storage Enclosure With Bezel
microsystems
System power LED
System summary fault LED
Drive activity LEDs
Nameplate