Sun Microsystems StorEdge S1 AC100, Installation And Maintenance Manual

Page: 77 / 128

Chapter 3 Installing the StorEdge S1 Enclosure 41
▼
To Set the SCSI IDs for the Drives
1. At the rear of the enclosure, locate the SCSI ID switch.
FIGURE 3-14
SCSI ID Switch on the Rear Panel
2. Set the SCSI ID address for the base address (first address in a drive series) in the
storage enclosure by pressing the square switch on either side of the number with
a pointed object.
Pressing the right switch increments the address; pressing the left switch decrements
it. You might want to write this number on the module bay label for front viewing.
For example, to use SCSI ID addresses 2, 3, and 4 for the first StorEdge S1 unit, set
the SCSI toggle switch to 2.
FIGURE 3-15
SCSI ID Address Switch on the Rear of the Storage Enclosure
Right switch
increments
address
Left switch
decrements
address
ID
SCSI ID address switches