Sun Microsystems StorEdge S1 AC100, Installation And Maintenance Manual

Page: 90 / 128

54 StorEdge S1 AC100 and DC100 Installation and Maintenance Manual • March 2002
Note –
Do not remove the two screws that are immediately to the left of the DC
connectors, flush against the chassis. Those screws hold the DC connectors in place.
Remove the two screws to the left of the two screws that hold the DC connectors in
place, the screws that are raised slightly from the chassis.
3. Locate the two chassis ground isolation bushings in the ship kit.
4. Insert the two bushings and screws into the screw holes and tighten the screws.
FIGURE 3-26
Securing the Chassis Ground Connection Screw
Powering On the Storage Enclosure
After all of the SCSI cables and power cables are attached to the StorEdge S1 storage
enclosure, power on the enclosure as described in the following procedure.
▼
To Power on the Storage Enclosure
1. Before turning the storage enclosure power on, check the binary SCSI LED
display with the power in standby mode.
See “To Check the Binary SCSI ID LED Display” on page 69 for information on
reading the binary LED display.
2. Press the power switch at the rear of the storage enclosure to the On (|) position.
See
FIGURE 3-19
for the location of the power switch. Note that when you release the
power switch, it settles into the center (neutral) position, the power remains on, and
the system summary fault LED on the front and rear panels turns from amber to
green.