Sun Microsystems StorEdge S1 AC100, Installation And Maintenance Manual

Page: 88 / 128

52 StorEdge S1 AC100 and DC100 Installation and Maintenance Manual • March 2002
FIGURE 3-23
Connecting the DC Input Power Cable to the DC Connector
10. Repeat Step 9, connecting the second DC input power cable to the other DC
connector at the rear of the enclosure.
Refer to
FIGURE 3-22
for the locations of the DC connectors on the DC power supplies
at the rear of the enclosure.
11. Turn on the circuit breakers to provide power to the enclosure.
To disconnect the DC input power cable from the DC connector, squeeze the two
tabs on the sides of the DC input power cable and gently disconnect the DC input
power cable from the DC power supply.
Note –
As soon as the system is connected to a power source, it goes into Standby
mode. The amber System Summary Fault LED comes on to reflect this; it does not
indicate a fault.