Black plate (43,1)
一
般
Model "A2510GE-B" EDITED: 2015/ 6/ 25
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks.
When the rear center seating position is
not occupied, lower the head restraint to
improve rearward visibility.
&
Reclining the seatback
(Outback)
WARNING
To prevent the passenger from slid-
ing under the seatbelt in the event of
a collision, always put the seatback
in the upright position while the
vehicle is in motion. Also, do not
place objects such as cushions
between the passenger and the
seatback. If you do so, the risk of
sliding under the lap belt and of the
lap belt sliding up over the abdomen
will increase, and both can result in
serious internal injury or death.
CAUTION
When using the cargo area cover,
observe the following precautions.
.
Be careful not to pinch your hand
between the headrest and the
cargo area cover when you re-
cline the rear seat.
.
Move the front cover of the cargo
area cover backward so that the
cover is not damaged by the
reclined seatback. Refer to
“
Adjust the seatback to the desired position
while pulling the lever.
After adjusting the seatback, release the
lever and make sure the seatback is
securely locked into place.
Seat, seatbelt and SRS airbags/Rear seats
1-13
–
CONTINUED
–
1
