Still RX60 25-35, Original Instructions Manual

Page: 474 / 518

Checking the condition and wear of the
tyres
–
Remove any foreign bodies embedded in
the tyres (1).
The level of wear exhibited by tyres on the
same axle must be approximately the same.
Superelastic tyres and solid rubber tyres can
be worn down to the "60J wear limit" (2).
If the truck is to be used in winter conditions in
areas where the StVZO (German Road Traffic
Licensing Regulations) applies, the profile
must be at least 4 mm.
Superelastic tyres may then only be operated
as far as the "60J wear limit" (2) if their profile
is re-cut and at least 4 mm deep.
Checking wheel fastenings
–
Check that the wheel-fastening screws (3)
of the drive axle and the wheel-fastening
nuts of the steering axle are securely in
place and re-tighten as necessary.
–
Note the tightening torques specified in the
"workshop manual".
Servicing the steering axle
–
Park the truck securely.
–
Check if any of the joints of the steering
axle have been knocked out.
–
Check the steering axle for bent parts.
Lubricating the steering axle
ENVIRONMENT NOTE
Dispose of old grease and contaminated devi-
ces in accordance with the national regula-
tions for the country in which the truck is being
used.
The joints of the steering axle each have four
lubricating nipples per side.
–
Apply grease to the lubricating nipples for
the steering axle in accordance with the
6301_901-004
60
J
60
J
1
2
3

Maintenance
5
Preserving operational readiness
460 56378011526 EN - 03/2021 - 01