Still RX60 25-35, Original Instructions Manual

Page: 281 / 518

If the calculation was successful, the meas-
ured weight of the load (1) is displayed.
NOTE
If the tare function was not active, the full
weight of the load being picked up is dis-
played.
The measured weight remains displayed until:
●
The load has been measured again
●
The sensor system detects a change in the
weight
In this case,
-.-- t
is displayed as the
weight.
Tare function
The tare function is a sub-function of the preci-
sion load measurement function. If the preci-
sion load measurement function should not
factor in the weight of a load container, the
tare function must be run. It is then possible to
determine the net weight of the raised load.
NOTE
During the following process, the fork carriage
must be lowered slightly. When doing so, the
fork must not touch the ground, as otherwise
the result will be inaccurate.
–
Set the lift mast to vertical.
–
Pick up the empty load container, such as a
crate.
–
Raise the fork to a height of between
300 mm and 800 mm.
–
Press the button.
The first menu level appears.
–
Press the "Load" softkey .
–
Press the "Precision load measure-
ment" softkey.
0,0°
0,70 m
1,5
t
1,32 t
6219_003-224
1


Operating
4
Load-dependant assistance systems
267 56378011526 EN - 03/2021 - 01