Still RX60 25-35, Original Instructions Manual

Page: 263 / 518

–
Reduce the driving speed on descending
gradients.
It is not permitted to drive on long ascending
and descending gradients greater than 15%
due to the specified minimum braking and sta-
bility values.
–
Before driving on ascending and descend-
ing gradients greater than 15%, consult the
authorised service centre.
The process of placing loads into stock and
removing loads from stock while on an as-
cending or descending gradient is not permit-
ted!
–
Always place loads into stock and remove
loads from stock on a horizontal plane.
Driving on lifts
The driver may only use this truck on lifts with
a sufficient load capacity and for which the op-
erating company has been granted authorisa-
tion (refer to the section entitled "Definition of
responsible persons").
DANGER
There is a risk of fatal injury from being crushed or
run over by the truck.
–
There must not be any persons already in the lift
when the truck is driven into the lift.
–
Persons are only permitted to enter the lift once
the truck is secure, and must exit the lift before
the truck is driven out.

Operating
4
Handling loads
249 56378011526 EN - 03/2021 - 01