Still RX60 25-35, Original Instructions Manual

Page: 240 / 518

WARNING
There is a risk of tipping!
The weight and dimensions of the fork extension af-
fect the stability of the truck. The permissible weights
stated on the capacity rating plate must be reduced
in proportion to the actual load distance.
If the truck is equipped with a fork extension ex
works, then the capacity rating plate will already
have been adjusted accordingly.
–
Observe the load capacity; refer to the chapter en-
titled "Before picking up a load".
NOTE
If the truck is equipped with the "load meas-
urement" comfort feature (variant), a "zero ad-
justment of the load measurement" must al-
ways be performed after the fork arms have
been changed. Otherwise, correct load meas-
urement cannot be guaranteed.
Attaching
DANGER
Risk of fatal injury from falling load!
At least 60% of the length of the fork extension must
lie on the fork arm. No more than 40% of the length
of the fork extension may overhang the end of the
fork arms. In addition, the fork extension must be se-
cured against slipping from the fork arm.
If the fork extension (1) is not secured with a secur-
ing bolt (2) and linch pin (3), the load may fall, along
with the fork extension.
–
Push the fork extension all the way to the back of
the fork.
–
Make sure that 60% of the length of the fork ex-
tension is on the fork arm.
–
Always secure the fork extension with the secur-
ing bolt.
–
Always secure the securing bolt with the linch pin.
–
Remove the linch pin (3) from the securing
bolt (2).
–
Remove the securing bolt from the fork ex-
tension (1).
–
Push the fork extension onto the fork arms
until the fork extension is flush with the fork
back.
7071_003-104_V2
1
2
3

Operating
4
Lifting
226 56378011526 EN - 03/2021 - 01