Still LTX 50, Original Instructions Manual

Page: 86 / 286

●
(4) F1 - Indicator light
F1 acts exclusively as an indicator light and
does not enable or disable any functions if
pressed:
Indicator flashing with the operator on the
ground
Indicator switched off with the operator on
board the truck
●
(5)Hazard warning signal (where present)
The button (5) is only present on certain
truck versions.
When the key (5) is pressed, the button
lights up and the four arrows start to flash.
When the key (5) is pressed again, the but-
ton and the four arrows turn off.
●
(6) F2 - Indicator light
F2 acts exclusively as an indicator light and
does not enable or disable any functions if
pressed:
Indicator flashing with the operator on the
ground
Indicator switched off with the operator on
board the truck
●
(7) Right indicator (where present)
The button (7) is only present on certain
truck versions.
When the key (7) is pressed, the button
lights up and the right indicator turns on.
When the key (7) is pressed again, the but-
ton and the right indicator turn off.
Turn on the indicator (7) before turning
right.
●
(8)Funzione Blue-Q
The Blue-Q function enables maximum opti-
misation of battery consumption.
When the key (8) is pressed, the button
lights up and the Blue-Q system switches
on. The Blue-Q function remains active
even after the truck is turned off and turned
on again.
To deactivate the Blue-Q system, press the
key (8) again. The button turns off and the
Blue-Q system is deactivated.
●
(9)Tortoise function
The tortoise function activates the truck's
creep speed.
When the key (9) is pressed, creep speed is
activated. The button lights up and the tor-
toise symbol (13) appears simultaneously.
The function remains active even when the
truck is turned off and turned on again.
When the key (9) is pressed again, the tor-
toise function is deactivated. The button (9)
turns off and the tortoise symbol (13) disap-
pears.
Describing the screen
●
(10) Battery charge level indicator
The battery charge level indicator is made
up of ten status bars. When the battery is
fully charged (100%), the ten status bars
are all lit. As the battery capacity decrea-
ses, the battery status bars decrease. If the
amount of charge reaches 30%, only three
status bars will remain lit and the battery
must be recharged. When the amount of
charge reaches 20%, two status bars will
remain lit and the truck's performance will
be automatically limited.
●
(11)Type of alarm
The truck alarms are displayed in this area.
Each alarm is identified by a letter followed
by three digits.
CAUTION
Contact the manufacturer's authorised sales net-
work.
●
(12)Warning triangle
The warning triangle (12) appears in the fol-
lowing cases:
- Incorrect switch-on sequence
- Active truck alarms In this case, the warn-
ing triangle turns on together with the type
of alarm (11).
- Flashing light when the battery reaches
30% charge. Recharge the battery.
- Steady light when the battery reaches
20% charge. In this case, the truck's per-
formance will be automatically limited if you
continue to use the truck.
●
(13)Tortoise indicator
The tortoise symbol indicates that the truck
is operating at creep speed. Creep speed is
controlled by the button (9).
●
(14)Hour meter
The information displayed by the hour me-
ter is linked to the activation or deactivation
of the Blue-Q function (8).
Overview
3
Instruments and controls
76 45878043344 EN - 11/2021 - 12