Still LTX 50, Original Instructions Manual

Page: 100 / 286

Automatic turning off of the flashing beacon
a few seconds after the operator climbs off
the platform with the truck turned on.
Automatic turning on again of the flashing
beacon a few seconds after the operator
climbs back on the platform with the truck
turned on.
(4 -5 - 6 - 7) Arrows (available only on
LTX50)
The arrows (direction indicators) indicate the
turning direction. To activate them:
●
Turning on the arrows on the left-hand side
When the key (C) is pressed, the push but-
ton lights up and the arrows (4 e 6) on the
left-hand side turn on.
●
Turning off the arrows (4 e 6) on the left-
hand side
The arrows turn off automatically when the
steering wheel is brought back to the neu-
tral position after turning.
Alternatively, when the key (C) is pressed
again, the push button and the arrows on
the left-hand side turn off.
●
Turning on the arrows on the right-hand
side
When the key (D) is pressed, the push but-
ton lights up and the arrows (5 e 7) on the
right-hand side turn on.
●
Turning off the arrows (5 e 7) on the right-
hand side
The arrows turn off automatically when the
steering wheel is brought back to the neu-
tral position after turning.
Alternatively, when the key (D) is pressed
again, the push button and the arrows on
the right-hand side turn off.
The arrows turn on automatically in the follow-
ing cases:
●
If there is an alarm on the truck (the arrows
turn on in intermittent mode). See "Prob-
lems and Resolutions" section.
●
While in pedestrian mode, when the steer-
ing wheel is turned at an angle greater than
the permitted value set by the manufactur-
er. In this case, the arrows turn on in inter-
mittent mode. The arrows turn off automati-
cally when the steering wheel is turned
within the permitted angle (about 10°).
The simultaneous activation of all the arrows
(hazard lights) (4 -5 - 6 - 7) is designed to sig-
nal an emergency situation due to a malfunc-
tion or other reason:
●
When the push button (E) is pressed, the
hazard lights turn on. The hazard lights and
the push button (E) start to flash.
●
When the push button (E) is pressed again
a second time, the hazard lights turn off.
The hazard lights and the push button (E)
turn off.
(6 e 7) Multifunction lights (available on-
ly on LTX50)
The multifunction lights (6 e 7) turn on in three
cases:
●
Brake lights. They turn on automatically
during braking.
●
Side lights. They turn on automatically
when the dipped-beam lights (9) are turned
on
●
Arrows (direction indicators). For more in-
formation, read the description above
(4 -5 - 6 - 7)
(8) Working spotlight (available only on
LTX50)
The working spotlight is turned on or off via
the switch (F).
(9 - 6 - 7) Dipped-beam lights (available
only on LTX50)
The dipped-beam lights improve safety in the
workplace. The front lights (9) illuminate the
truck's route; the rear lights (6 e 7) make the
truck more visible to other operators.
●
The dipped-beam lights are turned on via
the push button (A). For operation, read the
information above about the LED light bar
(1).
(10) Reverse lights (available only on
LTX50)
The reverse lights (10) warn that the truck is
travelling in reverse:
●
The reverse lights turn on automatically and
only when the truck is travelling in reverse.
Overview
3
Options and variants
90 45878043344 EN - 11/2021 - 12