Still LTX 50, Original Instructions Manual

Page: 121 / 286

only to be carried out if lead batteries are
used)
●
The operator must be qualified to drive the
truck The operator must be able to reach
and operate the controls Do not obstruct ac-
cess to the controls
●
Check the operator platform:
Visually check that the platform is in good
condition
Check that it is operating correctly
In the absence of the pedestrian mode with
steering wheel option, perform the following
check. Switch on the truck. Then, the oper-
ator must get down from the driver's com-
partment and stand on the ground next to
the truck. Leaving the steering straight, turn
the steering wheel travel controls slightly.
Check that the truck is operating correctly.
The truck must remain stationary and must
not be driven.
●
Check that the battery retainer is in good
condition and correctly positioned and se-
cured
●
Check that the battery is stable and proper-
ly secured in the appropriate compartment
●
Check that the lift chain holding bracket
(where present) is in good condition and
properly fastened
●
The roller tracks of the mast (where
present) must be coated in a visible film of
grease
●
The chains must be undamaged and must
be evenly and adequately tensioned (where
present)
●
The mast's protective screen must be intact
and correctly mounted (where present)
●
Visually check that the towing hook is in
good condition and correctly secured to the
truck Test that the towing hook is working
properly (where present)
●
Visually check that the adjustable seat is in
good condition (where present). Check that
the seat is operating correctly:
Do not drive the truck with the fold-away
seat down without the operator seated.
When the operator gets up from the fold-
away seat, the seat must close automatical-
ly.
●
Check that the buzzer signalling when the
truck is travelling in the direction of the fork
arms works correctly (where present)
●
Operational check for pedestrian mode with
steering wheel option (if present):
Switch on the truck. Then, climb down from
the truck (leaving it switched on) and check
that the indicators (F1) and (F2) are activa-
ted and flashing correctly.
Use
4
Checks and actions prior to commissioning
111 45878043344 EN - 11/2021 - 12