Still LTX 50, Original Instructions Manual

Page: 120 / 286

Checks and actions prior to commissioning
List of checks before use
WARNING
Damage or other faults on the truck or attachments
(special equipment) can result in accidents.
If damage or other faults are noticed on the truck or
attachments (special equipment) during the following
checks, do not use the truck until it has been proper-
ly repaired. Do not remove or disable the safety sys-
tems and switches. Do not change the pre-set val-
ues.
CAUTION
Only use the truck if all of the covers are fitted cor-
rectly and the covers and doors are closed correctly.
CAUTION
Perform checks on a flat surface. Make sure that
there are no people or objects in the test area in front
of and/or behind the truck.
CAUTION
Drive very slowly during the operational tests.
Ensure that the vehicle is in good working
condition prior to start-up. These checks sup-
plement and do not replace the scheduled
maintenance operations.
●
Check that there are NO oil leakages in the
area under the truck
●
Visually check the uncovered sections of
hydraulic hoses and pipes to ensure that
they are in good condition and to detect any
oil leakages
●
Check that there are no objects (wires of
various types, nails, screws, pieces of tape
etc.) impeding the operation of the wheels
and rollers The wheels and the load rollers
must roll freely
●
The wheels must not show any sign of dam-
age or heavy wear. They must be correctly
mounted
●
Check that the battery hood is properly and
fully closed
●
Check that all of the hoods and protective
guards are present and check that they are
correctly mounted
●
There must be no objects on the truck that
may limit visibility
●
Check that NO stickers are missing or dam-
aged Replace damaged or missing stickers
in compliance with the marking position ta-
ble
●
Visually check that the forks or other load-
carrying equipment show NO obvious dam-
age (e.g. bends, cracks, significant wear)
●
Check that the battery male connector and
socket are fully intact and in good condition
Check that they are working correctly
●
Check that the start/stop key works correct-
ly
●
Check the indications on the display
●
Check that the horn works correctly
●
Check that all the buttons and the travel
controls on the steering wheel are operating
correctly
●
Turn the steering wheel from both sides and
test that, when released, it automatically re-
turns to the centre position
●
One at a time, push the buttons and then
release them Check that the buttons return
automatically to their initial positions The
buttons must not remain activated or stuck
●
Turn the travel control and then release the
travel control Check that the travel control
returns automatically to its initial position
when it is released The travel control must
not remain activated and locked
●
Test that the truck brakes to a stop when
the travel control is released
●
Check that the emergency brake button on
the steering wheel is operating correctly
Perform the test when you are travelling
very slowly and are away from dangerous
areas
●
Test that the electromagnetic brake works
effectively
●
Check that the battery harness is in good
condition
●
Check the electrolyte level and density as
indicated in the battery instructions (check
Use
4
Checks and actions prior to commissioning
110 45878043344 EN - 11/2021 - 12