122
14 January 2021, SmartScanIS User’s Guide for Union Pacific, EUD-2016026-00 Rev.2
7
On the outside of the rail, mark this location.
This mark should correspond to the first mark on the opposite rail.
Use a permanent marker, magic marker, lumber crayon, or paint pen to mark the rail.
Don't use a file or punch to mark the rail.
8
Place the alignment fixture across both rails and adjust it so that the north or east side
of the adjustable gauge slide is even with the two rail marks.
The fixture should be snug against the top and gauge of both rails.
9
Remove the reflector block from the vertical alignment bar.
10
Install the vertical alignment bar with the target sight tilted toward the bearing scanner.
11
Install the reflector block in the top of the scanner cover with the sloping surface facing
the target.
The setup for the
Type II
bearing scanner is shown below.
Summary of Contents for SmartScanIS
