272
14 January 2021, SmartScanIS User’s Guide for Union Pacific, EUD-2016026-00 Rev.2
Heading
Contents of Field
CS Slope
Parms
These are the Carside Slope alarm parameters currently defined in the
system setup. These values were in place at the time the train passed the
site.
The value after CS Min is set by the
Carside Minimum option
on
the Alarm Limits submenu.
The value after CS Slope is set by the
Carside Slope option
on the
Alarm Limits submenu.
Chapter 11 - Serial Interface
tells how to set these values.
Wheel
Rail orientation for each side of the train. If the track orientation is east and
west, rails are north and south. If the track orientation is north and south,
rails are east and west. This field only appears when Hotwheel alarm
reporting is enabled using the
Hotwheel option
on the Equipment submenu.
Max
The maximum temperature (above ambient), in degrees Fahrenheit,
recorded by the wheel scanner on a given railside. This field only appears
when Hotwheel alarm reporting is enabled using the
Hotwheel option
on
the Equipment submenu.
Avg
The average temperature (above ambient), in degrees Fahrenheit,
calculated from all recorded temperatures from the wheel scanner on a given
railside. This field only appears when Hotwheel alarm reporting is enabled
using the
Hotwheel option
on the Equipment submenu.
Resistor
Read
The scanner resistor temperature (read after train passage), in degrees
Fahrenheit, recorded by the wheel scanner on a given railside. This field
only appears when Hotwheel alarm reporting is enabled using the
Hotwheel
option
on the Equipment submenu.
Resistor
Req
The resistor temperature, in degrees Fahrenheit, required by the wheel
scanner on a given railside to avoid a Cold Wheel Scanner Resistor alarm.
This value was calculated using the amount of time the shutters were open
and the Resistor Integrity Test Mode in effect at the time the train passed the
site. If the
Resistor Integrity Test Mode option
is disabled, a zero appears
in this field. This field only appears when Hotwheel alarm reporting is
enabled using the
Hotwheel option
on the Equipment submenu.
Summary of Contents for SmartScanIS
