STC SmartScanIS, User Manual

Page: 146 / 391

146
14 January 2021, SmartScanIS User’s Guide for Union Pacific, EUD-2016026-00 Rev.2
4 Using a wire stripper, remove 1/4 inches (6.4 millimeters) of insulation from both ends
of both conductors.
5 Using a pliers-type crimping tool, crimp one ring terminal to the end of each of these
four conductors.
6 If you haven't done so already, remove the two batteries from their boxes.
7 Place the batteries on the floor below the battery block.
To prevent damage to the system, attach the red wire before the black wires.
8 Using a 1/2-inch nutdriver, connect the red wire from the positive battery post to the left
side of the battery block.
9 Using a 1/2-inch nutdriver, connect the black wire from the negative battery post to the
right side of the battery block.
Your connections should now look like this.
10 Cut a red-black 10 AWG 2-conductor wire to fit between the battery block and the
SmartScanIS enclosure .
11 Using a wire stripper, remove 1/4 inches (6.4 millimeters) of insulation from both ends
of both conductors.
12 Using a pliers-type crimping tool, crimp a ring terminal to the end of the red conductor
and another ring terminal to the same end of the black conductor.
The end with the ring terminals attaches to the battery block. The other end attaches
to the terminal blocks in the SmartScanIS enclosure. The red conductor (positive) is
attached to the red terminal block and the black conductor (negative) to the black
terminal.