EUD-2016026-00 Rev.2, SmartScanIS User’s Guide for Union Pacific, 14 January 2021
293
The Polling System section, which is shown above, changes appearance slightly when the
system is configured for Dialup operation instead of Poll/Standalone operation.
•
•
•
Polling System - Dialup Mode
-------------------------------------------------------------------------
Primary
Phone#
[A,01]
18002345678
Secondary Phone#.......... Disabled
Site ID..................... NONAME
Calibration Temp.............. 180°
Wind Monitor.............. Disabled
Rail Stress Monitor............. NO
High Wind Alarm.............
32mph
Rail Stress Lim....
Low:-40 Hi:+40
•
•
•
The System Status report displays the
health-check interval
assigned to the enabled
telephone numbers. In the absence of communication with the Harriman Dispatch Center, this
interval defines the number of hours (up to 23 hours) allowed to pass before the system
initiates a dialup communication with Harriman. The letter in the bracket is either A for "all
passing trains" or D for "defect trains only." If 00 follows the letter, the health check is
disabled.
The table below lists the fields on the System Status report and the contents of each field.
Heading
Contents of Field
Milepost
The five-digit milepost of the site.
Chapter 11 - Serial Interface
tells how to
set this value using the Milepost submenu.
Rail
Rail orientation. Tracks running north/south have east/west rails. Tracks
running east/west have north/south rails. Valid values are N/S and E/W.
Track
The track designator of the site. For single-track sites, the value is Single.
For multitrack sites, valid values are 1, 2, 3, 4, 5, and 6.
Chapter 11 - Serial
Interface
tells how to set this value using the Track Number submenu.
SiteID
The name of the site. This can be supplied either by the Harriman Dispatch
Center via the Polling System or by the
Site ID option
on the Polling System
submenu. The default is
NONAME
.
Ambient Temp The ambient temperature, in degrees Fahrenheit, at the time this report was
generated.
AC
The AC signal status, taking the form "AC:xxx (nnn:nn)." The word "Off" or
"On" takes the place of the characters "xxx." This is followed by the amount
of time, in hours and minutes, that the AC signal has been lost. A display of
"AC:Off (123:45)" indicates that AC power is off and that it has been off for
123 hours and 45 minutes (just over 5 days). If the AC signal is present, the
item appears as "AC:On (0:00)" and shows a time value of zero.
Battery
Voltage
The battery voltage at the time this report was generated.
Summary of Contents for SmartScanIS
