STC SmartScanIS, User Manual

Page: 171 / 391

EUD-2016026-00 Rev.2, SmartScanIS User’s Guide for Union Pacific, 14 January 2021
171
9.9 Checking the Speech Data
The Vocabulary Test option is used to enunciate all of the stored speech phrases. This
announcement is broadcast through the speaker (inside the SmartScanIS enclosure), but not
through the radio.
Below is a list of the phrases that are announced. The phrases are grouped by chip number.
Chip Announced Phrases
1 Zero, One, Two, Three, Four, Five
2 Six, Seven, Eight, Nine, No-Defects
3 Detector-Malfunction, Point, Hotwheel, Testing
4 Axle, Dragging-Equipment-Near, North, Rail
5 South, East, West, Track, Hotbox
6 Defect-Detected, M-P-H, Fifth
7 Integrity-Failure, Detector-Out, Sixth
8 No Rebroadcast, Minutes, Train-Too-Slow, Total-Axles, Speed
9 A, B, C, D, E, Temperature, Length, Minus, First, Second
10 F, G, H, I, J, Third, Fourth, Left-Side, Right-Side, beep
11 K, L, M, N, O, High-Load, Wide-Load, On, Seventh, Eighth
12 P, Q, R, S, T, S-P-Detector, Milepost, Detector-Working
13 U, V, W, X, Y, Stop-Your-Train, U-P-Detector, Ninth
14 Z, Sliding-Wheel, Car-I-D, From-Head-of-Train, Degrees, Number
15 Multiple-Hot-Journal-and-Dragging-Equipment, Power-Off, High-Wide-Near
16 Detected-From-Axle, To-End-of-Train, Miles-Per-Hour, Multiple-Dragging-Equipment
To check the integrity of the speech data:
1 Be sure that the speaker (inside the SmartScanIS enclosure) is plugged in and that its
volume knob is turned to the middle position.
2 Using the serial interface, display the Main menu.
Chapter 11 - Serial Interface tells how to display the Main menu.
3 Select the Setup Menu .
4 At the password prompt, type uptest