STC SmartScanIS, User Manual

Page: 220 / 391

220
14 January 2021, SmartScanIS User’s Guide for Union Pacific, EUD-2016026-00 Rev.2
Note that the duty cycle for the scanner heaters now runs the heaters continuously at
ambient temperatures of 32 degrees Fahrenheit or lower.
Milepost-0501.2, Track:Single
Equipment
---------------------------------------------------
A) Dragger...................... NO
B) Hot Wheel.................... NO
C) High Load.................... NO
D) Wide Load.................... NO
E) Carside Slope................ NO
F) Talker Mode......... Talk Freely
G) Snow Cycle................... NO
H) AEI......................... YES
•
•
•
a From the Equipment submenu, select Snow Cycle .
The snow-cycle setting toggles between enabled (YES) and disabled (NO). The
Snow Cycle option on the Equipment submenu changes.
If you disabled the snow-cycle setting, the Equipment submenu reappears. If you
enabled the snow-cycle setting, this prompt appears.
Enter Start Month (1-12)
If the new start value is one digit long, you can type a leading zero to make it two
digits long or you can press
[Enter] after typing one digit.
b If you disabled the snow-cycle setting, skip the steps below and return to step 3 .
c To not change the starting and ending values, press [Esc] and return to step 3 .
d Type the new starting value.
If you type zero or a value greater than 12, this error message and prompt appears.
Minimum valid value is 1, Maximum valid value is 12
Enter Start Month (1-12)
If you type an acceptable value, this prompt appears.
Enter End Month (1-12)
e If you get an error message, return to step c .
f To not change the ending value, press [Esc] and return to step 3 .