STC SmartScanIS, User Manual

Page: 261 / 391

EUD-2016026-00 Rev.2, SmartScanIS User’s Guide for Union Pacific, 14 January 2021
261
7 To get the serial interface to come up, press [Esc] .
The Main menu appears.
STC Integrated Detector System, Milepost-0501.2, Track:Single
05/31/2013
9:35
Main Menu
------------------------------------------------
A) Train Summary
B) Train Detail
C) Exception Summary
D) Exception Detail
E) System Status
F) Last Train
G) Range of Trains
H) Event Log
I) Setup Menu
J) T94 Train Detail
X) Exit Menu
At the above prompt, you can produce one of the listed reports by selecting the
appropriate option.
8 When done, close the LOG file.
9 To exit the serial interface and return the SmartScanIS to normal operation, type x
When a session ends, if a modem was used, the system sends various commands to
the modem to prepare it for future use. If at any time during the disconnect procedure,
lines such as “+++ATH0” appear on your screen, these are merely commands
preparing the modem for further use. They shouldn’t be construed as anything that is
meant for the user.
10 If on-site and if you unplugged a device from COM3, plug the device back in after
unplugging your computer.
12.1 Train Summary Report
The Train Summary report lists all trains currently stored in the Trains directory. A train
number is shown for each train entry so that a Train Detail report may easily be produced for
any train listed on the summary.