STC SmartScanIS, User Manual

Page: 298 / 391

298
14 January 2021, SmartScanIS User’s Guide for Union Pacific, EUD-2016026-00 Rev.2
3 Type the starting train number.
If you typed four digits, the prompt below appears.
4 If you typed one, two, or three digits, press [Enter] .
This prompt appears.
Ending Train#
If you press [Enter] at the above prompt (without typing anything), the firmware
automatically sets the ending train number to the newest stored train.
5 Type the ending train number.
If you typed a valid four-digit train number, a Range of Trains report is produced, oldest
train first. If either of the typed train numbers is invalid, a message like this appears.
Train number not in range of currently stored trains.
Current range is:
Oldest Train = 11 Newest Train = 234
At this time, you can produce another report by selecting the appropriate menu option.
6 If you typed one, two, or three digits, press [Enter] .
If you typed a valid train number, a Range of Trains report is produced, oldest train
first. If either of the typed train numbers is invalid, a message like this appears.
Train number not in range of currently stored trains.
Current range is:
Oldest Train = 11 Newest Train = 234
At this time, you can produce another report by selecting the appropriate menu option.
7 When done, close the LOG file.
8 To exit the serial interface and return the SmartScanIS to normal operation, type x
9 If on-site and if you unplugged a device from COM3, plug the device back in after
unplugging your computer.
12.9 Event Log Report
The Event Log report is used for diagnostics. As certain system events occur, entries are
posted into the event log. Each time an entry is made into this log, it receives an event
number, the date and time that the event was recorded, and an event description.