Page 76
4.
Install the new pulley assembly, and install the belts.
5.
Install the upper Poly-V belt and pivot the alternator up or down as
necessary to allow ¼” of deflection at the midpoint between the two
pulleys (see Figure 20).
6.
Reinstall the side cover.
Lower Poly-V Pulley
1.
Remove the left side cover.
2.
Remove the lower Poly-V belt.
3.
Remove the snap ring and washers from the drive shaft, loosen the two
lower pulley set screws and slide the pulley off the shaft.
4.
Verify that the drive shaft key is fully inserted into the key way when
installing the new pulley.
REAR SUPPORT BAR
1.
Remove the safety panel.
2.
Remove the step cover.
3.
Have an assistant help you tilt the machine forward onto the console
handlebar.
4.
Remove the step.
5.
Remove the mounting bolts and washers from the rear support bar
PARTS REMOVAL AND REPLACEMENT
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE
PROTECTION WHEN REMOVING SNAP RINGS.
WARNING
!
Summary of Contents for FREERUNNER 5600
