Page 47
The Brake Tests
Use this test to verify that the brake limit switches are triggered correctly.
Adjust the limit switches if these tests fail. For replacement procedures refer to
the cable section of “Parts Removal and Replacement. “
Continuous cycle verification:
1.
Remove the left side cover.
2.
Position pedals so that they are bottom-dead-center. The software picks
up a signal from the stride sensor and will not allow braking if the stride
sensor detects that the pedals are apart.
3.
Press [ LEVEL: ^ ], [ 6 ], [ 4 ], [ENTER] to cycle the motor continuously.
Verify that the brake cam is triggering the upper and lower limit
switches and that the cam is not hitting the mechanical stops (see
Figure 30).
4.
Press [CLEAR] to end the test.
Brake “ON’ and Brake “OFF” verification:
5.
Press [ LEVEL: ^ ], [ 6 ], [ 5 ], [ENTER] to start the test. Press the
[ LEVEL: ^ ] key. Verify that the “Motor Dir” LED (#6) turns on and stays
on, and that the “Motor On” LED (#7) turns off for approximately 2
seconds and then turns on and stays on.
6.
Press the [ LEVEL:
∨
] key. Verify that the “Motor Dir” LED (#6) turns
off and stays off, and that the “Motor On” LED (#7) turns off for
approximately 2 seconds and then turns on and stays on.
7.
Press [CLEAR] to end the test. Reinstall the side cover.
TROUBLESHOOTING
Summary of Contents for FREERUNNER 5600
