Page 73
4.
Remove the drive shaft assembly.
5.
Remove the mounting block screws and washers from the bottom of
the machine, and remove the mounting blocks.
7.
Remove the heel link idler sprockets and the drive chain idler
sprockets from the mounting blocks.
8.
Attach the drive chain idler sprockets and the heel link idler sprockets
to the new mounting blocks.
9.
Install the new mounting blocks. Do not reverse the right and left
mounting blocks.
10.
Reassemble the machine in reverse order, and adjust the top edge of
the heel link pivot assembly so it is parallel with the floor (see
Figure 27).
PEDAL ASSEMBLY
1.
Disengage the brake and push the pedals apart.
2.
Remove the six cover fasteners from the pedal cover, and lift the
cover, with the foot strap, off the pedal support (see Figure 25).
3.
Remove the foot strap mounting fasteners from under the pedal
cover.
4.
Remove the four mounting screws from the rear bearing block of the
pedal support.
5.
Remove the snap rings and washers from the pedal shafts.
PARTS REMOVAL AND REPLACEMENT
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE PROTECTION WHEN REMOVING
SNAP RINGS.
WARNING
!
Summary of Contents for FREERUNNER 5600
