Page 44
• Place alligator clips on the B+ terminal and the field terminal of the
alternator.
• Step on the machine for 15 - 20 seconds.
• If resistance is achieved during this time, your alternator has
correct current flow.
• If no resistance builds up during this time, you either have a bad
alternator or bad alternator brushes.
12.
Unplug the diode from the FLD terminal of the alternator.
13.
Use a multimeter set to ohms to test the diode. A good diode will
show a high resistance reading in one direction and a low resistance
reading when the multimeter leads are reversed.
14.
Unplug the load resistor from the power control board. Set your
multimeter to ohms. Insert the multimeter leads into the load resistor
plug.
15.
A load resistor in proper working condition should read approximately
0.5 ohms. If there is no resistance when measured by a multimeter,
replace the load resistor.
16.
Check the main cable assemblies for continuity and cross check each
wire in the cables to test for shorts in the cable.
17.
Contact our Customer Service Department at (800) 331-3578 for
assistance. International customers should contact their local
distributors.
TROUBLESHOOTING
Summary of Contents for FREERUNNER 5600
