Stairmaster FREERUNNER 5600, Owner'S Manual

Page: 24 / 111

Page 15
“ BOTH NOT LOCKED” - allows either telemetry or contact
heart rate signals to be detected. Does not lock out a particular
input signal for the entire workout. This option will detect either
input signal during a workout session, but only one at a time, and
only until the other signal terminates.
“ TELEMETRY ONLY “ - locks out contact heart rate signals
and will only detect telemetry signals.
Your console should be
set to this option.
“ HAND ONLY “
- locks out telemetry signals and will only detect
contact heart rate signals. Do not use this option on this machine.
“ BOTH HR OFF “ - turns off the ability to detect any signal at all.
Used in rare situations where there is excessive interference with
the heart rate signals. This option disables the Constant HR
program and the Fitness Test program.
Error Messages
Text line messages are only seen in the Constant Heart Rate and Fitness Test
programs due to the design of the program that necessitates a valid heart rate
signal at all times during the program. For these programs, ensure that neither
the “BOTH HR OFF” or the “HAND ONLY” option is set as a default option.
“
CHECK HR BELT
” - The heart rate signal has been missing for the
last 30 seconds in telemetry signal detection.
“HR BELT NEEDED” - No telemetry belt signal been sensed during the
initial setup time.
“HOLD HR SENSORS” - In contact heart rate signal situations this
message will come every 30 seconds to prompt the user to hold the
sensors.
“
HR MODE DISABLED ” - No heart rate signal is allowed due to the
set up option that was chosen. Heart rate monitoring is not possible.
HEART RATE MONITORING