Page 54
PARTS REMOVAL AND REPLACEMENT
BEARINGS
Bearing Block – Heel Link
1.
Remove the side cover.
2.
Remove the pedal shaft housing from the pedal and pivot the pedal
forward.
3.
Remove the heel link flange bearing, jam nut, and heel link
sprocket. Use the heel link turnbuckle to loosen the heel link chain.
Keep track of the shaft key.
4.
Remove the heel link from the bearing block assembly.
5.
Remove the four mounting screws from the bearing block assembly and
set the bearing block assembly aside.
6.
Install the new bearing block assembly, reassemble the machine, and
adjust the top edge of the heel link pivot assembly so that it is parallel
with the floor (see Figure 27).
Bearing Block – Leg Assembly
1.
Remove the pedal and the side cover.
2.
Loosen the drive chain turnbuckle.
3.
Remove the leg link flange bearing. Remove the jam nut and washer
from the leg assembly shaft.
4.
Remove the leg assembly from the bearing block assembly.
5.
Remove the four mounting screws from the bearing block assembly.
6.
Install the new bearing block assembly, reassemble the machine, and
adjust the top edge of the heel link pivot assembly so that it is parallel
with the floor (see Figure 27).
Summary of Contents for FREERUNNER 5600
