Sony BVP-9500WS, Maintenance Manual

Page: 64 / 390

2-2 (E)
BVP-9500WS/9500WSP MM
Basic Operations
1. To display the maintenance menu, set the DISPLAY switch from “OFF” to “MENU” while pushing
the ENTER/CANCEL switch to the “ENTER” side.
The maintenance menu will be displayed on the viewfinder.
2. To select a page or setting item, rotate the MIC 1 LEVEL knob and move the cursor to the page or
setting item to be set, and then press the MIC 1 LEVEL knob.
3. To change a setting value, rotate the MIC 1 LEVEL knob. (Turning it fast, the value changes greatly,
while turning it slowly, the value changes slightly for fine adjustment.)
Pressing the MIC 1 LEVEL knob finalizes the setting.
4. To cancel a setting or return to the original screen, push the ENTER/CANCEL switch to the “CAN-
CEL” side.
5. To exit from the menu, switch the DISPLAY switch to “OFF.”
Entering the OHB Trimming Page
Use the OHB trimming page to register the data adjusted when a board is replaced as an OHB file. This
page is not displayed at shipment to avoid incorrect operations.
To display this page, perform the followings.
1. Set S3-4 switch on the AT-128 board to ON. (Refer to Section 1-2.)
2. While pushing the ENTER/CANCEL switch to the “ENTER” side, set the DISPLAY switch from
“OFF” to “MENU.”
The OHB trimming page will be displayed on the maintenance menu.
n
Be sure to reset S3-4 switch on the AT-128 board to OFF after using the OHB Trimming page during
adjustment.
2-1. Maintenance Menu