Sony BVP-9500WS, Maintenance Manual

Page: 50 / 390

1-40 (E)
BVP-9500WS/9500WSP MM
1-9. CCD Unit
Lug
(For BVP-9500WSP only)
PS2.6
x
5
PS2.6
x
5
B3 x 8
B3
x
8
Screws
For BVP-9500WSP only
Screws Front panel
CCD unit
Lug
1-9-3. Replacing the CCD Unit
c
When opening the side panel during or immediately after use of the unit, be careful as the board panel is
very hot and touching it may result in burns. When opening the side panel to perform inspections and
adjustments, turn off the power and wait 10 minutes for the unit to cool down first.
n
for BVP-9500WSP
Two earth lugs from the CCD unit are fastened with two screws for the PR guard.
Be sure to do steps 1 and 2 to prevent the damage of earth lugs.
1. Remove the right side panel. (Refer to Section 1-4 in the Installation and Maintenance Manual.) (For
BVP-9500WSP only.)
2. Remove the two screws. (For BVP-9500WSP only.)
3. Loosen the four screws, and remove the CCD unit with the front panel attached.
4. Remove the four screws (B3 x 6), and remove the front panel.