3-29 (E)
BVP-9500WS/9500WSP MM
C
B
A
C
A
[NTSC]
[PAL]
3-3-10. VBS Y Level Adjustment
Equipment:
Waveform monitor
Preparations
.
Extend the EN-141 board with the extension board (EX-762 board assembly or EX-464.)
.
Connect the waveform monitor to the TEST OUT connector/side panel.
.
Disconnect the triax cable or optical fiber cable from CCU.
.
Supply power from the AC adaptor (AC-550/550CE).
.
OUTPUT switch/side panel
→
BARS
Adjustment procedures
1.
Test point:
TEST OUT connector/side panel
Adj. point:
1
RV606 (VBS Y SYNC) /EN-141 board
Specification:
A = 40
±
1 IRE [NTSC]
A = 300
±
5 mV [PAL]
2.
Setup level adjustment (UC model only)
Test point:
TEST OUT connector/side panel
Adj. point:
1
RV607 (VBS Y SETUP) /EN-141 board
Specification:
B = 7.5
±
1.0 IRE
3.
Test point:
Pin 50/EX-762 or EX-464 board
GND:
Pin 49/EX-762 or EX-464 board
Adj. point:
1
RV605 (VBS Y) /EN-141 board
Specification:
C = 100
±
1 IRE [NTSC]
C = 700
±
5 mV [PAL]
3-3. Encoder System Adjustment
Summary of Contents for BVP-9500WS
