1-29
FVS-1000 MMP1
Lens
Lens control cable
Lens mount lever
Reference pin
Connector
Lens control cable
Imager movement table assembly
1-10. Installation Procedure
(7) Install the lens of which the protection cap is removed to the imager, then turn the mount lever in the
direction of arrow as shown in the following figure to fix.
(8) Connect the lens control cable with the connector of the imager movement table assembly.
(9) Insert the imager movement table assembly, then tighten the lock.
(10)Close the rear door.
(11)Close the door opened in the step (2), then fix with the two screws.
Imager movement table assembly
Lock
Lock