2-12
FVS-1000 MMP1
2-4. Film Threading
2-4. Film Threading
This unit is designed so that the film cannot be driven unless the front door is closed due to the danger of
touching the film driven with the hand, etc.
For this reason, stop running when removing the film, and open the front door after standby off.
m
.
Do not open the front door during film running.
If opened, film running will stop instantaneously.
.
Never give shocks to the main unit FVS-1000 during film running. Or picture-shifting may occur.
.
For the FVS-1000, as the file is run by gearing the perforations of the film with the teeth of the sprock-
et, if the film has been spliced, be sure to open a perforation which suits the standard of the film.
If there is not perforation, the film may be cut during running.
.
Be sure to perform STANDBY ON or STANDBY OFF operations at the start or end of film winding.
1.
Open the front door.
2.
Set the supply reel and takeup reel.
3.
Pull out the film from the supply reel, then feed it along the path shown in the above figure.
4.
Wind the top of the film on the takeup side reel round two or three times.
n
Do not fix the film to the center of the reel with adhesive tape.
If the film is wound automatically, the film may be cut.
5.
Close the front door.
6.
Operate with the control panel.
GR4
Drum for the analog audio
When install the analog audio
Drum for the
analog audio
Takeup reel
GR10
GR8
GR9
T continuous
sprocket
T intermittent
sprocket
GR7
Supply reel
GR1
GR3
GR5
GR5
GR2
S continuous
sprocket
S intermittent
sprocket
GR4
Film
