3-3
FVS-1000 MMP1
3-2-1. Cleaning the Gate Base (35) / (16)
Assembly
Removal
1.
Set a unit in the STANDBY OFF mode.
2.
Turn off the power.
3.
Release the two one-touch fixing screws with turning
90 degrees counterclockwise, pull the gate base
assembly in the direction of arrow, then remove it
from the guide pin.
4.
Remove the adherence with air etc.
5.
Clean the top of the gate with the cleaning cloth to
which the cleaning fluid is applied.
6.
Wipe the cleaned surface with a dry cloth two or three
times.
Installation
7.
Install the gate base assembly in the reverse order of
removal procedure 1 to 3.
n
When installing, be careful not to hit the gate base
against the sprocket.
[Reference]
When the groove (
_
) of the one-touch fixing screw is
almost horizontal, the assembly is fixed.
3-2. Cleaning the Running System
One-touch fixing screws
Gate base (35) assembly
Guide pin
Guide pin
Sprocket
Sprocket
Film guide(G)
Film guide pins
E guide
E guide
Film guide pins
Gate base (35) assembly
This illustration shows the gate base (35) assembly.
Cleaning
Clean