animeo IB+
4 Zone/8 Zone TouchBuco BACnet
2020/04/30
Seite 26
Selecting the temperature sensors used:
1. Outside temperature (Out. Temp.)
2. Inside temperature: Two Inside Sensor Boxes, each with two sensor connections, can be connected. As
such, you can select a maximum of four sensors.
Threshold Sun
If the solar intensity is above the "Threshold Sun On", the selected position is approached. If the solar inten-
sity is below the "Threshold Sun Off", the function is deactivated.
Adjustment range from 0 kLux to 65 kLux.
Threshold Temperature
If the temperature is above the "Threshold Temperature On", the selected position is approached. If the tem-
perature is below the "Threshold Temperature Off", the function is deactivated.
Adjustment range from -40 °C to +40 °C.
Delay time On/Off
Delay time adjustment range from 0 to 255 minutes.
Block Heat On
Setting the position of the motorized product with heat in % (100 % = closed) and the angle in ° (for Venetian
blinds), adjustment range up to 90° = closed.
Block Heat Off
Setting the position of the motorized product after enabling the function:
•
No Action:
The motorized products remain stationary in position.
•
Standard:
The motorized products move to the standard position. The standard position needs to be
defined once (s. chapter 6.5.1 System Settings).
•
Position:
The motorized products moved to the set position. In the case of Venetian blinds, the
defined angle is set.
•
My Position:
The motorized products move to the intermediate position programmed in the motor
controller.
6.3.3 Solar Heating
When the inside temperature is too low, solar radiation can be used to warm up the building. The motorized
products are then moved to a suitable position, e.g. completely open. The function is enabled based on
brightness and the inside temperature. To enable the function, you need to move the "Solar Heating" slider
to the right.
You can navigate through the setting using the grey "forward" and "backward" arrows.
Sun Sensors Used
Selecting the sun sensors: When setting the sensors, you selected between Compact Sensor (only three sun
sensors) and Outside Sensor Box (up to eight sensors). You now need to specify which sun sensors are to
be used as reference for this zone. When using multiple sensors, the highest value always applies.
Temperature sensor used
In this zone, you specify which temperature sensors are to apply as reference for this zone.
Selecting the temperature sensors used for the inside temperature: Two Inside Sensor Boxes, each with two
sensor connections, can be connected. As such, you can select a maximum of four sensors.
Summary of Contents for animeo IB+ 4 Zone Touch Building Controller
Page 49: ......