animeo IB+
4 Zone/8 Zone TouchBuco BACnet
2020/04/30
Seite 17
Enabling the function:
To enable the Frost or Ice function, you need to move the "Frost/Ice" slider to the
right.
Setting the Frost/Ice function:
Threshold "On":
Adjustment range from 0 °C to 40 °C.
Delay time:
Adjustment range "On" from 0 to 255 seconds. Adjustment range "Off" from 0 to 3000 minutes.
Rain History
(only for ice function): Adjustment range from 0 to 255 hours.
Frost/Ice On:
Lock Only
The end products/shades in a zone stop moving and low-priority manual and automatic com-
mands are locked.
Up Priority
The end products/shades in a zone move to the upper end limit and low-priority manual and
automatic commands are locked.
Down Priority
The end products/shades in a zone move to the lower end limit and low-priority manual and
automatic commands are locked.
6.1.4 Wind
Wind sensors used
This function is used to protect end products/motorized products from high wind speeds for safety reasons.
In the event of a wind alarm, further operator commands (local operation via buttons, radio control, etc.) and
automatic commands with low priority are locked. The "IB" LED on the motor controller lights up red to indi-
cate that commands have been locked. If the wind direction sensor is also installed, individual zones can be
protected from strong wind. In this case, the number of wind speed sensors can be minimized. The wind
direction sensor therefore only protects the selected zone, meaning that not all end products/motorized
products are moved to the safety position.
Wind function
If the measured wind speed is above the wind threshold for a period at least equal to the "Delay Time On",
the wind function is activated. The behavior of the end product/motorized product can be defined. The "delay
time off" starts counting as soon as the wind speed drops below the threshold. The function is released as
soon as the "delay time off" has elapsed.
Wind function for application ZIP screen
If the measured wind speed exceeds the "low wind" threshold for a period at least equal to the "delay time
on", the product can only be raised or stopped using the local control. If the measured wind speed exceeds
the "high wind" threshold for a period at least equal to the "delay time on", the product is moved to the
selected position. The behavior of the end product/motorized product can be defined. The "delay time off"
starts counting as soon as the wind speed drops below the threshold. The function is released as soon as
the "delay time off" has elapsed.
Wind Direction
This function is only possible when the wind direction sensor and at least one wind sensor are enabled. If the
measured wind speed is above the "Wind Direction" threshold for a period at least equal to the "Delay Time
On" and the wind direction is within the monitored range (from 0° to 360°, whereby 0° is due north), the wind
direction function is active. The behavior of the end product/motorized product is the same as with the wind
alarm. The "Delay Time Off" starts counting as soon as the wind speed drops below the threshold and the
wind is outside the monitored range. The function is enabled as soon as the "Delay Time Off" has elapsed
and the wind direction is no longer in the range specified.
You can navigate through the setting using the grey "forward" and "backward" arrows.
Enabling the functions:
To enable the “Wind”/”Wind Direction” function, you need to slide the "Wind”/”Wind
Direction" slider to the right.
Summary of Contents for animeo IB+ 4 Zone Touch Building Controller
Page 49: ......