animeo IB+
4 Zone/8 Zone TouchBuco BACnet
2020/04/30
Seite 28
Threshold Sun
If the solar intensity is below the "Threshold Sun On", the selected position is approached (100 % = closed).
If the solar intensity is above the "Threshold Sun Off", the function is deactivated. Adjustment range from
0 kLux to 65 kLux.
Threshold Temperature
If the inside temperature is below the "Threshold Temperature On/Off", the selected position is approached.
Note: The outside temperature should be at least 5 °C lower than the inside temperature. Otherwise, the
function is not enabled. Adjustment range from 0 °C to 40 °C.
Delta Temperature
The "Maintain Heat" function is enabled when the difference in temperature (outside < inside) exceeds the
value set under "Inside/Outside".
The "Maintain Heat" function is deactivated when the difference in temperature (outside < inside) falls below
the value set under "Inside/Outside".
Delay time On/Off
Adjustment range from 0 to 255 minutes.
Maintain Heat On
Setting the position of the motorized product in % (100 % = closed) and the angle in ° (for Venetian blinds),
adjustment range up to 90° (= closed).
Maintain Heat Off
Setting the position of the motorized product after enabling the function:
•
No Action:
The end products/motorized products remain stationary in position.
•
Standard:
The end products/motorized products move to the standard position. The standard
position needs to be defined once (s. chapter 6.5.1 System Settings).
•
Position:
The end products/motorized products move to a set position. In the case of Venetian
blinds, the defined angle is set.
•
My Position:
The motorized products move to the intermediate position programmed in the motor
controller.
6.3.5 Cooling
This function allows you to open and close windows based on the inside and outside temperature. The func-
tion should ideally be used outside the room usage times (e.g. during the night).
The function is only active when the outside temperature is within the setpoints specified (On/Off).
To enable the function, you need to move the "Cooling" slider to the right.
You can navigate through the setting using the grey "forward" and "backward" arrows.
Temperature sensor used
In this section, you specify which temperature sensors are to apply as reference for this zone.
Selecting the temperature sensors used: Two Inside Sensor Boxes, each with two sensor connections, can
be connected. As such, you can select a maximum of four sensors.
Summary of Contents for animeo IB+ 4 Zone Touch Building Controller
Page 49: ......