animeo IB+
4 Zone/8 Zone TouchBuco BACnet
2020/04/30
Seite 22
The delay times "On" and "Off" are typically different. The delay time "On" is generally relatively short (e.g. 3
minutes), while the delay time "Off" typically lasts a bit longer (e.g. 15 to 30 minutes). This prevents too many
travel commands from being executed in changeable weather conditions.
"Sun On":
Position:
Setting the position of the motorized product with sun as % (100% = closed, with end prod-
ucts/motorized products) and the angle of the blinds in ° (adjustment range up to 90°).
"My" position (intermediate position):
can also be selected
Suntracking:
Multiple positions are calculated dynamically on the basis of the position of the sun. Press
"Configure" to set the calculation values for the following four parameters:
Update Time
: How often is the position of the motorized product calculated? Adjustment range between 1
and 240 minutes. We recommend a value of 5 minutes.
Orientation:
Enter the alignment of the current zone here. 0° = North, 90° = East, 180° = South, 270° =
West.
Minimum Step:
When using Venetian blinds, the steps for turning the slats are specified in angular degrees.
When using vertical awnings, this step is specified in %.
Slat Ratio:
Designates the ratio of slat spacing to slat width. The spacing is generally slightly lower than the
actual width (overlap). The slats should ideally be aligned horizontally for measuring. A typical value is 0.9.
Screen Length:
Only used for sun position tracking with textile sun protection or with roller shutters (not for
Venetian blinds). The height corresponds to the window height.
Sun Depth:
Only used for sun position tracking with textile sun protection or with roller shutters (not for
Venetian blinds). How low may the sun shine into the room without generating glare?
"
Sun off:
Setting the behavior of the motorized product after enabling the sun protection function, i.e. when the sun
function is no longer active:
No Action:
The end products/motorized products remain stationary in position.
Standard:
The end products/motorized products move to the standard position. The standard position needs
to be defined just one time in the menu "System Settings” (s. chapter 6.5.1.System Settings)
Position:
The end products/motorized products move to a set position or, in the case of Venetian blinds, to
the set angle.
My Position:
The motorized products move to the intermediate position programmed in the motor controller.
Pre-open slats:
After 10 % of the sun "off" delay time, the slats of Venetian blinds are opened early. The position is main-
tained.
Azimuth Range and Elevation Angle:
If the solar radiation is outside the set angle, the end products/
motorized products are moved to the parametrised "Off" position. The horizontal angle and elevation angle
are defined in the "Azimuth Range" and "Elevation Angle" menus.
Summary of Contents for animeo IB+ 4 Zone Touch Building Controller
Page 49: ......