PCS – Pressure Control System
Leaflet for Quick Start - Valid for all versions
ATTENTION: The technical safety instructions in the operating manual must imperatively be
observed! Read carefully before the commissioning the complete operating and installation
manual Failure to comply will void the warranty!
Set the pressure points
1
2
3
4
5
6
7
8
9
10
11
12
13
Air supply Hose connection.ø6/4mm
Pressure gauge for the control pressure of the actuator
Throttle for the control pressure of the actuator
Infeed air throttle for setting the rotational speed
Discharge air throttle for setting the rotational speed
1)
Potentiometer for setting the pulse width
1)
Position indicator
Terminal zone for power supply and signal cable
Cable connection M20x1,5
LEDs for status indication
1)
Jumper socket J1-J7
1)
Valve block with Manual override
Digital pressure switch
1)
- Only for version PCS-U-…
Mode/Function
digital display
Mode/Function
Measurement mode
After switching on, after
about 5 seconds the
pressure switch is in the
measurement mode.
F0 – phyical unit
with
select
and with confirm
Pressure point P_1
o
with change
F01 / F02
Set the pressure points
Select output 1 or 2
pressure point P_2
o
with change
Set the pressure
points P_1
O
and
P_2
O
Menu
with
select
and with confirm
Set the
hysteresis
for
P_1 / P_2
P_1
O
- H_1 = P_1
U
Keys lock
with
select
and with confirm
F81 - PIN
– Query at
unlocking the key lock.
S
witching on/off
with
and with confirm
Commissioning
PCS-U
PCS-E-…-M
-
Connect the compressed air
(Plug-in connector with hose connection ø6/4mm)
-
Connect the power supply and signal cables acc. to the
terminal connection diagram
-
Set the pressure points, if different than the
Status at delivery (see reverse side)
