-11-
No. JXC
※
-OMT0002-C
3.2 Mounting the controller
Refer to
4.4 Mounting
for instructions on how to mount the controller.
3.3 Install the setting software and the driver
Install the controller setting software and driver software on the PC to be used.
For details, refer to the Installation Manual for the controller setting software (No.SFOD-OMT0008).
3.4 Wiring and connection
Connect the cables to the controller.
Refer to section
2.3 Product Configuration
,
6.2 Wiring
, and
7. EtherNet/IP Communication
Connector
for wiring details.
3.5 Power supply, Start-up of controller setting software, and Alarm check
(1) Supplying power
After supplying power for the motor control and motor drive, turn on the power supply for the main
control.
LED and
switch
Colour
Status
PWR
Green
ON: Power ON
OFF: Power OFF
RUN
Green
ON: Operating
Flashing: Operation by the
setting software
OFF: Not operated
USB
Green
ON: USB connected
OFF: USB not connected
ALM
Red
ON: Alarm is generated
OFF: Alarm is not generated
Check that the PWR LED is ON.
If the green PWR LED is not ON, check the wiring of the power supply and the power supply
voltage.
Caution
After supplying power for the motor control and motor drive, turn on the power supply for the main
control. Otherwise a
“Modbus Error” alarm will be generated.