![background image](http://html.mh-extra.com/html/smc-networks/2888w-m/2888w-m_owners-manual_1300139072.webp)
Initial Configuration
5-8
Note:
Available channel settings are limited by local regulations which
determine which channels are available.
3. IP Configuration
– Either enable or disable (Dynamic Host
Configuration Protocol (DHCP) for automatic IP configuration.
If you disable DHCP, then manually enter the IP address and
subnet mask. If a management station exists on another
network segment, then you must enter the IP address for a
gateway that can route traffic between these segments. Then
enter the IP address for the primary and secondary Domain
Name Servers (DNS) servers to be used for host-name to IP
address resolution.
•
DHCP Client –
With DHCP Client enabled, the IP
address, subnet mask and default gateway can be
dynamically assigned to the access point by the network
DHCP server. (Default: Enable)
Note:
If there is no DHCP server on your network, then the access point
will automatically start up with its default IP address, 192.168.2.2.
Summary of Contents for 2888W-M
