Command Line Interface
7-62
wds channel
This command selects the radio band to be used for WDS
forwarding (bridging).
Syntax
wds channel
<
a
|
g
|
none
>
•
a
- Bridging is supported on the 802.11a 5 GHz band.
•
g
- Bridging is supported on the 802.11b/g 2.4 GHz band.
•
none
- Bridging is not supported for either band.
Default
802.11a
Command Mode
Global Configuration
Example
wds mac-address
This command enters
Ethernet MAC Addresses
in the WDS
forwarding table for each node in the wireless bridge network.
Syntax
wds mac-address
<
port-id
> <
mac-address
>
•
port-id
- The wireless port number for the bridge link. (1 for
Slave units; 1-16 for Master units)
•
mac-address
- The
Ethernet MAC Address
of the remote
bridge unit for this link. (12 hexadecimal digits in the form
“xx-xx-xx-xx-xx-xx”)
Default
none
AP(config)#wds channel a
AP(config)#
Summary of Contents for 2888W-M
