![background image](http://html.mh-extra.com/html/smc-networks/2888w-m/2888w-m_owners-manual_1300139298.webp)
Troubleshooting
A-2
3.
If the wireless bridge cannot be configured using Telnet, a
web browser, or SNMP software:
•
Be sure to have configured the wireless bridge with a valid
IP address, subnet mask and default gateway.
•
Check that you have a valid network connection to the
wireless bridge and that the Ethernet port or the wireless
interface has not been disabled.
•
If you are connecting to the wireless bridge through the
wired Ethernet interface, check the network cabling
between the management station and the wireless bridge.
•
If you cannot connect using Telnet, you may have
exceeded the maximum number of concurrent Telnet
sessions permitted (i.e, four sessions). Try connecting
again at a later time.
4.
If all other recovery measures fail, and the wireless bridge is
still not functioning properly, take any of these steps:
•
Reset the wireless bridge’s hardware using the CLI, web
interface, or through a power reset.
•
Reset the wireless bridge to its default configuration.
5.
If you forgot or lost the password:
•
Contact Technical Support.
Summary of Contents for 2888W-M
