Siemens SITOP BUF8600, Manual, Page: 153 / 252

Engineering and remote access
7.4 SIMATIC STEP 7
PSU8600power supply systems
Manual, 04.2016, A5E35883207-7-76
153
Subgroup Description
Outputs 1 … 4 In these subgroups, make the following settings for the individual out-
puts:
•
Switch-on and switch-off output.
• Setpoint output voltage
•
Response threshold value of the output current
• Define a threshold for the output of an alarm.
An alarm is output if this threshold is continually exceeded for 5 ms.
•
Define the on delay.
• Define the ELECTRONIC SHUTDOWN or CONSTANT CURRENT
modes
Web server
•
Activate web server on this module
• Enable automatic update
•
Update interval
• Enable automatic logoff
•
Permit access only with HTTPS
General I&M
•
Contact
• Location ID
A detailed description of the individual parameters of the subgroups is provided in Sections
Parameterizing the basic unit (Page 154) and Parameterizing outputs (Page 159).
Parameters of the expansion modules
Subgroups "Outputs 1 … 4" are relevant when parameterizing expansion modules.
Subgroup Description
Outputs 1 … 4 In these subgroups, make the following settings for the individual out-
puts:
• Switching-in and switching-out outputs
•
Setpoint output voltage
• Response threshold value of the output current
•
Define a threshold for the output of an alarm.
An alarm is output if this threshold is continually exceeded for 5 ms.
• Define the on delay
•
Define the ELECTRONIC SHUTDOWN or CONSTANT CURRENT
modes
A detailed description of the individual parameters of the subgroups is provided in Section
Parameterizing outputs (Page 159).