Siemens SIMEAS R-PMU, Manual, Page: 138 / 296

12
12.2 Configuration
138
Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012
12.2 Configuration
‰
In the System control dialog, Configuration tab, you define the slot assignment of your
SIMEAS R-PMU.
Figure 12-8 Configuration tab
Proceed as follows to set the parameters:
‰
Click
8/16
in the
SIMEAS R-PMU Type
box for a 10“ device, or click
32/64
for a 19“ device.
‰
Select the nominal frequency from the drop-down menu of the
System Frequency
box and
the source of the reference frequency for the internal signal calculation in the
Frequency
Reference
box.
‰
Activate the DAUs of the individual slots by checking the
Slot Enable
checkbox.
Deactivate one or more slots, if you want to run your SIMEAS R-PMU temporarily without
some DAUs. the deactivated DAus can remain in your device or may be removed, e. g. for
recalibration. In any case, the parameters of these DAUs are preserved. After activation of a
DAU, the connection between current and voltage channels has to be done again.
‰
Select the type of the DAU from the drop-down menu of the
DAU Type
box.
Note
For the SIMEAS R-PMU type 8/16, only slot 1 can be parameterized. The slots 2 to 4 are
deactivated.
Note
If you deactivate a DAU and remove it from the device, the event recorder does not display the
data for this module slot any more. After re-insertion and activation of the DAU, these data are
visible again.