Siemens AXIOM Iconos R200, Operator'S Manual, Page: 100 / 238

Examination
Cassette Exposures in the Spotfilm Device (optional)
16
/ 52
AXD3-340.620.13.01.02 Operator Manual
Loading / unloading the spotfilm device
Loading
LED lights up: Cassette in unloading position.
◆ Insert the cassette with the smooth side upwards and insert at least 2/3 of the
cassette width into the loading shaft.
– The cassette is drawn in automatically and parked in the spotfilm device.
– At the same time the cassette format is measured and the LED in the cor-
responding segmentation key lights up.
– The cassette size is shown in the display of the system remote control con-
sole.
If a cassette format which is not approved is used, the cassette moves automat-
ically back into the loading position.
The cassette does not appear in the loading slot:
◆
Tilt the tabletop into the +45° position.
◆ Press the unloading key briefly a number of times until the cassette appears
in the loading slot.
In a table position of approx. 45° to 90° it can happen that if the cassette is not
inserted far enough it drops out from the loading shaft again on automatic center-
ing depending on its make/type. The formats 20 x 40 cm, 18 x 24 cm and
24 x 30 cm inserted in upright format are especially affected by this.
In this case,
◆
insert the cassette with its smooth side upwards and with at least 3/4 of the
cassette width in the loading slot
◆
hold the ball of your thumb against the cassette until it is securely grasped by
the cassette jaws.
Warning
Risk of injury during automatic cassette size sensing!
◆
Do not reach into the loading shaft of the spotfilm device.
Caution
Under no circumstances may you poke your fingers into the loading slot as this
would interrupt the sensing light barrier. Otherwise the cassette is rejected.