Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Version
11
Page 93 of 117
Status
Issued
Last Editor
Jeerh, Manpreet
Date
March 2020
Document
Name
WIMAG GENERAL HANDBOOK
Doc. No.
667/HB/47200/000
Copyright
©
Siemens Mobility Limited 2012. All Rights Reserved.
9. Disconnect the Ethernet connector from the front of the card.
10. Pull the interface card from the rack
11. Re-
apply the ‘configuration link.
12. Re-insert the card and re-connect the Ethernet cable back onto the front of the
card.
13. Re-connect to the interface card using the appropriate IP address.
14.
Confirm detection by observing the ‘Board Test’ facility
17.2.2 PoE Switch replacement
The PoE switch to be replaced will be one of two types; a four port or an eight port
(408/4/54225/000). Replacement PoE will only be as an 8 port variant. The following
instructions should be followed for a successful replacement;
1. Disconnect every Ethernet connection from the PoE switch. The field technician
should be aware of which port each cable was connected to.
2. Unscrew the terminal connector on the PoE switch.
3. Loosen then remove the grey end block, situated above the switch.
4. Un-clip the PoE switch. Alternatively, if there is room available, slide the switch
upwards and off the DIN rail.
5. Replacement is the reverse of removal.
