Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Version
11
Page 47 of 117
Status
Issued
Last Editor
Jeerh, Manpreet
Date
March 2020
Document
Name
WIMAG GENERAL HANDBOOK
Doc. No.
667/HB/47200/000
Copyright
©
Siemens Mobility Limited 2012. All Rights Reserved.
13. Re-insert the card and re-connect any required Ethernet cables from the front.
14. You may re-connect to the interface card using the appropriate IP address,
remembering to re set your laptop/pc’s Ethernet address accordingly.
15. Insert or connect to the next interface card, if applicable, and repeat steps 1 to 14.
16. Step 15 may be repeated for a third card.
7.2 Configuring Access Points, Repeaters and Sensors
The configuration of the access point, repeater and magnetometer sensor(s) are all
performed by using the Traffic Dot software application. The reader is to refer to the
‘Traffic Dot Set Up and Operating Guide’ for detail instructions on operating the Traffic
Dot application and configuration of the access point, repeater and sensors.
This section outlines specific settings that Siemens require, in order to operate the WiMag
vehicle detection system in an optimal manner.
Note:
Deviation from these settings is likely to mean the WiMag vehicle
detection system does not function correctly for traffic control.
Note:
Configuration of the access point requires the access point to be powered.
This is normally achieved by connecting the access point to a powered WiMag
Communications rack (reference section 10.2) or when using a WiMag Loop
Detector Replacement Card.
Note:
Apply settings to the access point via the TrafficDot configuration
software.
Note:
Ensure only a single access point is connected at any one time. This will
ensure that there are no IP connectivity issues, during the setup stage.
Note:
It is recommended, to aid installation, that each item in the system is
labelled/marked with its own identification and settings to ensure there is no
confusion during installation.
Table 8 : Configuration Guides
1
1
All documents are available on the Sensys website :
http://www.sensysnetworks.com/
Sensys Part Number
Document Description
P/N 152-240-020-002 Rev C
Quick Start Guide for RP240-B-LL Repeater
P/N 152-240-015-017 Rev A
Quick Start guide for FLEX-AP-ED Access Point
P/N 152-240-001-071 Rev B
Traffic Dot Set Up and Operating Guide
P/N P 510.548.4620 F
10.548.8264
VSN240-M MicroRadar
Sensor Installation Quick Start
Guide
