Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Version
11
Page 71 of 117
Status
Issued
Last Editor
Jeerh, Manpreet
Date
March 2020
Document
Name
WIMAG GENERAL HANDBOOK
Doc. No.
667/HB/47200/000
Copyright
©
Siemens Mobility Limited 2012. All Rights Reserved.
13
Installation of the WiMag Communications Rack
13.1 Overview
The 3U and 2U racks should be assembled in accordance with general assemblies
667/GA/47260/200 and 667/GA/47260/300 respectively. They can be installed into a
controller from the Factory or retrofitted into existing controllers. All components required
for installation will be included with assembled racks.
13.2 Installing the PoE Switch
Note
: The PoE switch should normally be pre-installed in the communications rack,
variant /100 only.
1. The 8 port PoE switch is slid down the DIN rail and secured with a terminal block
end stop.
2. Connect a non-PoE Ethernet port to the user maintenance Ethernet port using a
supplied Ethernet cable.
Figure 51 : 8 Port PoE Device showing two free non-PoE ports
(numbered 1 and 2)
